Truck, Tractor & Earthmoving - Manual Transmission and Differential Oils
Truck gear oil, axle oil and TO-4 drivetrain fluid
Greyhound Lubricants truck gear oil is specified for the heavy gearboxes, hub reductions and hypoid axles on trucks, buses, tractors and trailers. GL-4 (GL4) grades protect synchromesh gearboxes, GL-5 (GL5) grades handle the shock loads in drive axles and differentials, and 85W-140 covers the heaviest axles in hot conditions. For yellow equipment the TO-4 range provides transmission, final drive and wet brake fluid to Caterpillar TO-4 and Komatsu KES requirements in SAE 10W, 30, 50 and 60. Match the truck gear oil grade to the OEM manual, then choose 20 litre pails or 210 litre drums for the workshop.
How to choose a truck gear oil or drivetrain fluid
Match the GL rating to the component: GL-4 (GL4) for synchromesh truck gearboxes, GL-5 (GL5) for drive axles, hub reductions and differentials, and the limited slip grade where the axle plate calls for it. Viscosity follows load and climate: 80W-90 is the common all round truck gear oil, 85W-140 for heavy axles running hot on long hauls, and 75W-90 synthetic for extended drain programmes. On yellow equipment do not use a GL gear oil in the transmission or final drives; those call for a TO-4 fluid in the grade the OEM specifies, usually SAE 10W for transmissions and SAE 30 or 50 for final drives and wet brakes, because TO-4 fluids are built around clutch friction and brake chatter, not only gear protection. Every Greyhound truck gear oil and TO-4 page lists its rating, viscosity and pack sizes.
Monograde Mineral Gear Oils
Semi-Synthetic Gear Oils
None
Fully Synthetic Gear Oils

