Car, 4WD & Light Commercial - Engine Oil Additives
Engine oil additive and engine maintenance products
Greyhound Lubricants engine oil additive and maintenance products keep car and bakkie engines clean between services. G-Moto Engine Flush is added to the old oil before a change to loosen sludge and varnish so the fresh oil starts clean, and G-Moto DEF is the diesel exhaust fluid that modern SCR diesel bakkies and SUVs need to meet emission limits. Each engine oil additive page explains when to use it, how much to add and which engines it suits.
When to use an engine oil additive or flush
An engine flush is worth using when an engine has run past its service interval, has been topped up with mixed oils, or shows sludge under the filler cap: add it to the old oil, idle for the time stated on the pack, then drain and refill with fresh oil and a new filter. It is not a repair for worn engines and is not needed at every service on a well maintained car. Diesel exhaust fluid is different: it is not an engine oil additive at all and must never go into the engine or fuel tank. It goes into the separate DEF tank on SCR diesel bakkies and SUVs, where the vehicle doses it into the exhaust to cut nitrogen oxide emissions. Running out of DEF will put most modern diesels into limp mode. Each product page gives dosing, application and pack sizes.

