Industrial & Manufacturing - Heat Transfer Oils
Thermal oil for heat transfer heaters and process heating
Greyhound Lubricants thermal oil is a mineral based heat transfer fluid for closed loop heating systems in factories, food plants, laundries, asphalt plants, presses and dryers, where a pumped oil circuit carries heat from a boiler to the process. The ISO 32 grade pumps easily on cold start, resists oxidation and cracking at the bulk temperatures these systems run at, and keeps coke and sludge from forming on the heater tubes. The heat transfer oil page lists the operating range, the system types it suits and the pack sizes from 20 litre to 210 litre drums.
Running a thermal oil system
Thermal oil lasts for years if the system is run correctly and goes off quickly if it is not. Keep the expansion tank cold and sealed from air so the hot oil never meets oxygen, since oxidation is what turns a clear oil into acid and sludge. Do not exceed the film temperature on the heater tubes, which is why the burner controls and the circulation pump interlock matter. Sample the heat transfer oil once a year and test viscosity, acid number and flash point; a falling flash point shows cracking and a rising acid number shows oxidation. Top up with the same oil, and when the analysis says it is finished, drain hot and flush before refilling. Greyhound supplies heat transfer oil in 20 litre pails for small systems and 210 litre drums for plants.
Heat Transfer Oils

