Industrial & Manufacturing - Rockdrill & Chainsaw Oils
Air tool oil for rock drills, plus chainsaw oil
Greyhound Lubricants air tool oil for rock drills is a heavy ISO 320 oil fed through the air line lubricator to pneumatic rock drills, jackhammers, breakers and other air tools used in mining, quarrying and construction. It clings to the piston and valve surfaces through the wet, high velocity air inside the drill, resists washing out and protects against the rust that compressed air moisture causes. The chainsaw chain oil on the same page is a tacky bar and chain oil for petrol and electric chainsaws, formulated to stay on the chain at speed. Both pages list pack sizes from 5 to 210 litres.
Using air tool oil correctly
Rock drill oil goes into the line lubricator, not into the drill itself, and the drip rate should be set so a light film shows at the exhaust port; too little and the drill runs hot and wears the piston, too much and the operator breathes oil mist. Use the viscosity the drill manufacturer specifies, usually ISO 320 for drifters and jacklegs in warm conditions, and keep the air line water separator drained because water in the line emulsifies the oil. For the chuck and front end use a rock drill grease, not the oil. Chainsaw oil should be refilled every time the petrol tank is filled; running the bar dry for even a few minutes overheats the chain and bar. Greyhound supplies both in 5 litre packs for contractors and 20 and 210 litre packs for mines and forestry operations.
Rockdrill Oils
Chainsaw Oils

